I'm assuming it's just a straight vac pipe to the rear of the cluster for this to work again?
I think the original feed was used for the aftermarket gauge.
I'm assuming it's just a straight vac pipe to the rear of the cluster for this to work again?
I think the original feed was used for the aftermarket gauge.
Pipe goes from drivers side of carb top to o.e boost gauge.
As above ..
There is a plastic connector on the bulkhead, if it's there but unconnected then run some vac hose to carb top and should be sorted
Take a pic and post it on here for future
Nice one It's in an awkward little place