ok so on my little project im going to run some sort of charge air cooler. space means that if i fit an intercooler i will have to reduce the size of the rad, its already small so not feeling reducing its size. I could go custom and fit a cooler the same size as the rad and have a custom rad mounted directly behind it the same as a lot of manufacturers are doing though i have seen some nice tube type charge coolers. i could effectively run a pre rad as large as my rad and have a short pipe run. who has experience with them and any pros or cons? a cutom rad and cooler is going to cost and a custom prerad and charge cooler will also cost a fair bit though i could use my original rad in that setup. what route would best suit my needs?