Took the engine out over xmas and fitted a piper270 cam and gave the engine a clean up. Fitted cam and timed engine up, refitted all bits and dropped lump back in. While it was out iv replaced a few electrical connections, fitted a r21 dizzy cap and some magnecor leads - other than that no change from when i pulled it.
Today i primed oil feed to turbo, fitted oil feed and have been turning engine over but all it does is turn over and wont fire. What are the possible problem area?
All iv done is replace a few connectors so i dont think its wiring
Possibility... the magnecore leads dont fit into the r21 dizzy cap, they are all to close together and wont push on well atall - so possible no contact? (I would try my old dizzy cap/leads but they are at work...) Is anyone running r21 cap and magnecore leads - how did you get round this, trim the rubber down to allow fitting?
Timing is out??
Where i have removed the dizzy drive gear to fit cam iv put it back in wrong position?
Cheers guys for any pointers