Incase it's of any use to the Adaptronic lads on here I'll included a post I've just made on the Adaptronic forum about the Adaptronic drivers I wrote for WinLog.
If you're looking for a nifty way to view live data and log it then this is for you
Chris
---------------------
Hi Guys
I had a customer ask me if it would be possible to use the very handy, free version of WinLog with his Adaptronic e420c.
No one had written a device driver for it and since it would also be usefull to me I decided to write one.
I've included it here for download.
Its tested with some E420c's and an emulator. It should work fine with 440's too. It will not work with E420b !
Connect the laptop / PC running WinLog to the ECU in the same way you would when using WARI (for 440's it will be neccessary to connect a COM port to the Serial out jack).
What is WinLog ?
Go to http://www.devtechnics.com/winlog.htm to read about it, download it and so on.
Then download my driver bundle (for COM1, 2, 3, 4, 5 or 6) here: http://www.efi-parts.co.uk/downloads/Adaptronic_WinLog.zip
Read the included README.TXT. In short, you install WinLog, un-zip and copy the driver files (link above) in to a new directory (not the WinLog directory). Run WinLog, go to "File, Open Dashboard", navigate to the drivers directory and select "Adaptronic.dsh". Finally, go to "View, Device configuration" , "Add" , "Have disk" then navigate to the drivers directory and select the apropriate driver.
The dashboard is configured for the COM1 driver as default. You can right-click, then go to "Edit, Properties" on each of the gauges to set them to a different COM port driver if you wish.
You can fiddle with the dashboard (screen) layout all you like, I just included a basic one to get you going.
What can I log with this driver ?
RPM
AFR
MAP kpa
TPS %
Water temp
Air temp
Aux temp
Injector duty cycle (%) (a calculated average of the 4 injector outputs)
Ignition Advance
Fuel trim %
Knock (0-255)
Battery volts
Screenshot:
Feedback welcome,
Chris
www.efi-parts.co.uk
--------------