-
Non-member
Oil pressure gauge
Any thoughts on this one ???
Oil pressure gauge has been working fine since engine rebuild, but now either is intermittent or not working at all, it usually sits around 4 but now only just moves off the bottom...
Could it just be the sensor in the sump????
-
East Midlands Area Rep
Re: Oil pressure gauge
Sounds like a bad connection. Sensor in sump measures oil level then once engine running measures oil pressure. Look at connections on right hand side front of block below where turbo oil feed is and you'll see the pressure sensor underneath banjo, clean up connectors, may also be worth doing the level sensor on front of sump. It should switch from level to pressure however old french electrics can be a little unreliable.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules