-
Non-member
Anti roll bar
Do i have to remove the downpipe to take the anti roll bar off?I think the haynes mentions the gear selector also.Which bushes should i go for?and are they all the same id?
-
Ireland Area Rep
Re: Anti roll bar
Down pipe no as the anit roll bar will just slide over the exhaust gear selector yes and then just 4 bolts 13mm two inner and two outer anti roll brackets.
-
Moderator, Committee
Re: Anti roll bar
Weren't there two different ARBs fitted by Renault from the factory, having slightly different diameters? Some have the slightly smaller and some the slightly larger?? Is it 19mm and 21mm, I can't remember. A good search of the boards should help
-
Non-member
Re: Anti roll bar
Thanks guys.I have had a search and your right Trev.I will wait till the bar is off before i purchase the bushes.
-
Moderator, Committee
Re: Anti roll bar
Let us know how you get on Casper. Would you tell us what diameter yours is, where you get the bushes from and what they cost? Helps keep things current on the boards
-
Non-member
Re: Anti roll bar
Will do.There are three different sized bushes available 19,21,23mm.Just to make it easier.
-
Moderator, Committee
Re: Anti roll bar
Cool.
Weren't the 23mm ones only fitted to the diesel R5, or the van, or the Clio Williams or something though? I thought that was an upgrade some folk tried on the GTT?
-
Non-member
Re: Anti roll bar
So i spent the day rolling about on the garage floor and the arb is now off.The inner bushes measure 21mm internal diameter and measure about 30mm high.I have sent the arb off to be powder coated so should i order the 21mm bushes or take into account the powder coat and order 23mm?
-
Non-member
Re: Anti roll bar
Rally design bushes.What are they like?Which colour should i go for?
-
Committee, NW Regional Rep
Re: Anti roll bar
I have used both the yellow bushes and the red ones. The red ones are really solid but I never really noticed anything on the road. I guess if your current bushes have play then you might notice. I ended up with the wrong set for ordered the others and sent them back.
By the way you don't need to remove the whole anti roll bar to replace them
-
Non-member
Re: Anti roll bar
Managed to fit new wishbones and arb bushes.Turned out to be a pain in the arse and one you dont want to do to often.The advice given (g clamp) etc made it easier.I think the powdercoating made it harder but its done now and looks fresh.I did intend to fit the new koni suspension i have but will leave that untill next winter.
-
East Midlands Area Rep
Re: Anti roll bar
Cool, what bushes did you go for in the end? 'G' clamp is a top tip . Still got my full set of Koni's to fit when I buy top hats & bearings.
-
Non-member
Re: Anti roll bar
I used rally design bushes.
-
Committee, NW Regional Rep
Re: Anti roll bar
The easiest way to fit the inner bushes is to use really long bolts then cut them down a bit if needed Glad you got them sorted, it's always nice to have nice new stuff on the car
-
Moderator, Committee
Re: Anti roll bar
So you managed to squeeze the 21mm's over the powder coating? Cool
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules