-
Non-member
Fitting Stack Water Temp Gauge
Hi
I was wondering if anyone can help with a small problem we have fitting an aftermarket Water Temp Gauge?
We are fitting a STACK Water Temp Gauge to our 5 but are struggling to find an adaptor that will fit on the end of the Stack Sensor that then allows it to fit in the existing sensor housing in the engine?
This is the gauge
https://www.merlinmotorsport.co.uk/f...structions.pdf
It says is has a 1/2"NPT mounting nut or 3/8" BSPT?
Does anyone know anywhere that will sell the relevant adaptor we can fit on the end?
Picture below
-
Re: Fitting Stack Water Temp Gauge
Personally I would remove the end plate on the head (opposite side to the water pump) and drill n tap that.
-
Non-member
Re: Fitting Stack Water Temp Gauge
morning mate I think I got my adaptor from this site.
http://www.demon-tweeks.co.uk/motors...pipes-adaptors
-
Moderator, Committee
Re: Fitting Stack Water Temp Gauge
-
Non-member
Re: Fitting Stack Water Temp Gauge
Thanks all for your help
-
Non-member
Re: Fitting Stack Water Temp Gauge
alright mate ive got the exact same problem with the same gauge how did you get round it cheers
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules