-
Non-member
Hunting idle when cold
I have a 5 with an f7p from an r19. When I start it cold the engine hunts between 1.5k and 500rpm then just when it sounds like its cutting out it will rev up to 2k and start the hunting again. It never actually cuts out but it gets close. It only does it until the engine is warm then it idles fine.
If you try to drive straight after starting it still does the same and you have no power it just splutters a bit then it kicks in.
I thought maybe idle speed valve but as soon as the engine warms up it runs fine.
Any ideas?
Anyone had this before?
Thanks
-
Non-member
Re: Hunting idle when cold
This used to happen in my old valver.
Mark mentioned it could have been a cold start injector fault or just tired injectors overall.
Could be idle valve also
Get a few more opinions in an start trying different things mate
-
Non-member
Re: Hunting idle when cold
Had this on my valver and willy and it was the ISCV both times.
Or try the CTS (coolant temp sensor).
Last edited by Gtturbo; 03-10-2013 at 07:20.
-
Non-member
Re: Hunting idle when cold
Cheers guys
The cold start injector seems most logical so far as it only happens when cold.
I've had a valver before and had to replace the ISCV because something similar was happening, it was hunting when idle constantly then though, it didn't matter wether it was cold or warmed up.
That's what confuses me, the fact it's fine when warmed up.
I'm not much of a mechanic and didn't know that cold start injectors existed, how would I check something like that?
Thanks
-
Non-member
Re: Hunting idle when cold
I also remember when my ISCV went on my valver the car would drive fine, no spluttering or anything when pulling away.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules