-
very little oil flow through oil feed
New poster! (less than 10 posts)
i seem to have very low amount of oil passing through my oil feed to turbo but engine and oil pressure and gauge are reading fine, could this be a blockage? i have taken of the oil feed and even run the car and i get a dribble so im guessing its the stem on the oil pressure feed?
-
Non-member
Re: very little oil flow through oil feed
There is a non return valve under the turbo oil feed, it looks like an inch long nut. Check that isnt stuck/filled with ****e etc.
Are you using the standard oil pressure gauge or aftermarket? The original gauge is very unreliable.
-
Re: very little oil flow through oil feed
New poster! (less than 10 posts)
ok nice one i will give it a check, i am using a auto gauge not the o.e, cheers brigsy
-
West Midlands Area Rep
Re: very little oil flow through oil feed
Is your gauge plumbed in just before going to turbo? After the or one way valve like, aint got a filter on there too have you?
-
Re: very little oil flow through oil feed
If it's old it's probably filled with carbon deposits. Some of the old turbo feeds i've cut into after replacing have been shocking. Buy a new one.
-
Re: very little oil flow through oil feed
New poster! (less than 10 posts)
Std oil feed system using after market gauge off of original feed/sensor
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules