as titled........anyone have spares??
I need one for definate, untill I can inspect the rest properly..
this is what I get by showing a type R who the boss is
as titled........anyone have spares??
I need one for definate, untill I can inspect the rest properly..
this is what I get by showing a type R who the boss is
Hi Graeme, got loads in stock.
Hi mate just seen ya pushrod...
I've started doing sleeves for pushrods...
https://www.rtoc.org/boards/picture.p...pictureid=8174
£30 if you send me yours to be done...
Who won oh dear any other damage?
thank you for the reply's. No other damage.... engine was running ok, just sounded awful and rattling. I knew what it was instantly (happened twice before )
Flat shifting on the 7k rpm limiter obviously has its consequences
Sid - they look interesting, but how much is added onto the pushrod diameter with these sleeve's??
Currently looks tight between the pushrod and head as it is. And is that price for a full set of 8?
off the top of my head I reckon they go up to 5/16 o/d...in real money thats just under 8mm..
price is for set of 8..deliverd when you send me yours
cheers
That sounds like a good deal. But I will have to look closely at how much clearance there is in there and get back to you or perhaps buy another set and send them down as I would like to be mobile again asap.
I must have a reground cam as I had to move the securing nut to the underside of the rocker arm to adjust the tappets correctly
Nice one sid. I have seen the rockers, nice work
Unfortunately I have another project on the go just now (a house) so my pocket money has taken a nose dive and luxury purchases are out of bounds
here's a picture of uprated pushrod beside a standard one i used from another type of engine they where longer and cut down to suit reprofiled cam, you will need to make the holes bigger in the head as the pushrods will hit.good idea with the sleeves sid very clever