Ok so havnt got a remote and never heard an alarm, only thing that works is immobiliser. And I have the click click click vroom! Which I think iv traced down to bad alarm fitting so causing alot of resistance in the wirring from ignition.
1- This is in the bulk head, im guessing not standard fitment? So can I chuck it and about 10inches out of the wirring goes to a white plastic connector, is this genuine or can it all go?
2- a splice - can I just remove it?
3- wow! Earths under the steering wheel and goes to alarm wirring - just remove?
4-removed instruments and found this underneath - just remove?
5- now this block connector clips into the wirring which comes from the ignition barrel.as you can see the red wire has been spliced into the alarm, so can I just disconnect the splice here? And you can see the white wire has been cut just under my thumb with more wires added in, can I cut this and join it below to the white wire at bottom of pic as I think that's where it would originally go?
So basically can I remove all the alarm boxes and wirring and with the removed splices and the 2 wires properly joind from back of igniton barrel wirring that should be it?