Rumbling noise

[Brigsy]

My gt turbo has developed a deep rumbling/rubbing noise.

Basically its similar to a wheelbearing noise but not constant, it happens every couple of revolutions. It only happens between 30-60mph, regardless of rpm, gear, turning or braking doesnt affect it. Even with clutch pressed & coasting it makes no difference. Its hard to tell if it makes the noise under acceleration due to the exhaust.

Up to now i have changed both front wheel bearings, this has made no difference at all. I have also changed the gearbox oil.

Any suggestions? I have been advised it could be the tyres!? Im thinking the gearbox is noisy but unsure as they usually whine?

[GTphil]

Can you tell if it's coming from a particular side?

I'm pressuming you checked the passenger side shaft where it slots into the gearbox? I have seen the roller bearing things on the end of the shaft come off before now, you can usually feel it pretty consistently when that happens.

[Brigsy]

Its hard to say really, sounds more passenger side? Theres no vibration as of such so i assume the shaft is ok, they usually vibrate like feck if the tripod bearings collapse?

[Chunk]

Try changing the hubs for a different set and try a different set of driveshafts.

[markey b]

if you think its coming from one side, swap the wheels/tyres left to right and test it, if noise changes you know its them

[Brigsy]

Im going to swap wheels front to back later. I wonder if it is the fecking shafts? Id expect noise all the time and vibration though from previous experiences. Could it be a bearing on its way on the box?

[GTphil]

I got some cheapy part worn tyres fitted to my driving school car and they made it sound like a bearing was on it's way out, are the tyres old? I got kind of a droning sound, was worse on new/smooth tarmac. Changed the tyres for new budgets and hey ho the noise went away, maybe try another set of wheels/tyres?

[Brigsy]

Its got a fairly old set of uniroyals on like, i did swap front to back on passenger side recently but cant remember if the noise was present before or after.

[GTphil]

Chepest test is to stick another set of wheels and tyres on then if that doesn't solve it time to start taking things apart.

[Tony Walker]

Agree some tyres are much noisier than others, to the point where they sound like a wheel bearing is gone, tracking and camber out can also increase the tyre noise.

[Brigsy]

Changed tyres back to front no difference. The noise just starts before 30 and goes approx 40, its fecking annoying when driving round the streets. Thinking on it has made this noise for ages but nowhere near as loud. Looks like the only option is to ride it out and let it develop?!

[Ashy]

Changed tyres back to front no difference. The noise just starts before 30 and goes approx 40, its fecking annoying when driving round the streets. Thinking on it has made this noise for ages but nowhere near as loud. Looks like the only option is to ride it out and let it develop?!

You'll know what it is when it lets go

[Tony Walker]

Any particular gear?

[Brigsy]

Same in all gears, even coasting with clutch dipped

[andybond]

Nothin daft like the bottom pulley cover is moving around at those speeds and rubbing ? - you know the large plastic slab that "protects" the pulley from the water / salt etc splashing up

[J$£5GTT]

all i can think of is are the engine mounts all fine and you sure the exhaust aint touching anything?

[Dave Reed]

Could be the diff bearing or a wheel bearing

[jesus in the seat of a 5]

Could be the diff bearing or a wheel bearing

, got to agree with dave..mine turned out to be a wheel bearing, did exactly that..was even a new one, id also taken out the box...

[Scoff]

can you run it up on axle stands and listen for the noise ? the o/s shaft still has the pin in the inner spline doesn't it ?

[Brigsy]

As far as i know the pin is still fitted, aye going to run it up with both wheels off the ground, i did run it with drivers side off the floor and no noise

[Brigsy]

Well i ran it up on axle stands and no noise although the drivers side shaft seemed noisy when moving the steering hmm.

Went to the ring & back and its no worse after 1400 miles of abuse!? Still exactly the same.

[Os8472]

Dodgy CV joint maybe, got 1 on the 9, sounds like a wheel bearing