-
Moderator
South East Regional Rep
Removing Distributor
If i remove the distributor to give it a clean etc does it affect the timing etc for when I put it back in?
Or is it a case of just sliding it back into position and putting the bracket back on that holds it down??
Thanks
-
Committee, Shop Manager, SE Regional Rep
Re: Removing Distributor
Taking it out and removing its fine. it can only go in one way as the notch is slightly off centre
-
Moderator
South East Regional Rep
Re: Removing Distributor
Thankyou very much good advice as ever.
Still not fitted those engine mounts yet but I am nearly there!
Is it good practice to pop an old distributor in, attach it to a drill and spin it, just to prime the engine up after a rebuild?
-
Non-member
Re: Removing Distributor
Take the plugs out and turn it over on the starter, this should prime it up just fine.
-
Moderator
South East Regional Rep
Re: Removing Distributor
Thanks again
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules