Anyone know the thread size for the oil feed on the 200sx t28? Looks like an m10 with a 1mm thread pitch but I want to be sure as I have nothing to measure the thread with.
Anyone know the thread size for the oil feed on the 200sx t28? Looks like an m10 with a 1mm thread pitch but I want to be sure as I have nothing to measure the thread with.
There's one in Mitcham matey
Pirtek, Unit 11 Liongate Enterprise Park, 80 Morden Road, Mitcham, Surrey, CR4 4NY
Tel: (020) 8640 6565
nice one matey il pop down there
Make sure you find out though as I need one as well
will do
4an? is that a thread hose solutions are likely to use? Il call them but il most prob go down to pirtek with the turbo and old adaptor so i know it will fit.
If it helps steve il pick you one up just need to know how you want the other end.
he did mine so il get 2 of the same
Went to pirtec turns out its next door to where I get the car mot'd but they had nothing that would fit the turbo they had parts to fit the hose but not the turbo.
The search continue's...
I may ask CR Turbo's tomorrow if they know the size & then at least we can go from there with adapters ??
good shout matey. il find out the size of the oil feed hose thread from ben.
Guys it's a very funny size as I have tried loads of different adapters, the link I put up is the only one I could get to fit.
Im finding that out bud im going to keep trying but if worst comes to the worst il get that and an adaptor to fit my oil feed hose
I've just bought a fitting M14 - 4an, that way I can tell if it fits the oil pressure switch outlet & the turbo
Good man let me know how you get on
Also found this place http://www.speedflowshop.co.uk/male-...lers-103-c.asp
Ace one of those must do it. Im going to ring ben on monday as hes the only one who will know what the thread size is on the feed aparently they did say they did oil feeds for the 200sx t28's so they can find out the thread size for the turbo but not until bens back
Says 1/4 inverted flare so would have thought that end in the turbo. Could be wrong though.
Woop woop
So we want 1/4 not 4an to go into the turbo ...
Quite poss my oil feed is 4an female remember that being mentioned but not sure.
Im sure 4an was mentioned somewhere il wail til mon n see if ben can confirm that
Well I got an adapter M10x1mm & it's to small & the 1/4" I got was way too big (unless the ysent the wrong adapter).
The actual size according to CR Turbo's is: 7/16 UNS 24 tpi, they sell adapters for £17.50 + VAT & carraige...
fookin ell how much!!! i should be making these at work if i had the time.
Steve ben from hose solutions has them just tell him you want an adaptor when you get your oil feed hose made up. He sent me one out for free so it didnt feel right to ask for another one. I was hoping that he would tell me the size when he sent it but he kept that quiet Il give him a ring if ya want and see what he sent me if you like?
Is 8mm id hose enough for an oil return hose or does it need a larger dia bore ?
Have a look at this Steve, 8mm would be way to
Small. Think it should be somewhere around 14mm.
https://www.rtoc.org/boards/showthread.php?t=16387
the return on the b18ft is 16mm