I have pretty much got the engine cooling all sorted out just waiting for my rad to get delivered, also waiting for my itercooler to come in stock.
Thanks Dave for the plumbing help, i have followed the diagram as below i think i must have got it wrong with you over the phone, and thanks to Dave's lover Andy for the wiring help lol.
I just have a few questions on a few more parts what vac pipes do i run off the inlet? There is 3 on the drivers side pic 2.
There is one larger out of the rear of the inlet on the passenger side also a small vac one at the back and 2 vacs at the front next to the throttle body?
Also wheres the one from the throttle body go to?
I have the one running of the front to the idle control valve, what else need connecting up there? I'm not going to use that rubber black thing that sits on the breather, so do i just bung the hole at the rubber 90 next to the turbo?
There is a clear vac pipe coming of the recirc valve, where does that go?
Also the vac pipe that run from the black ecu where does that go to? It currently has a t piece in it to.
I am going to run a bleed valve so i guess this must change things, from a picture i have seen the bleed valve goes between the actuator to the bleed valve then out to the rear of the inlet.
Please any help you can guys.
Phil