Lower it , stretch tyres ,pastel paint and a roof rack ??? Keep NA and stroke it
http://cgi.ebay.co.uk/ws/eBayISAPI.d...tab%3DWatching
Who has some cheap cheap wheels that will suit ?
Lower it , stretch tyres ,pastel paint and a roof rack ??? Keep NA and stroke it
http://cgi.ebay.co.uk/ws/eBayISAPI.d...tab%3DWatching
Who has some cheap cheap wheels that will suit ?
Na just bang one of these in with 15 inch espace steelies. jobs a gud un
Lee, you might start liking renault 5's if your not careful
It's here .
Solid as a rock it seems with no rust of note anywhere I shall pop it in for MOT in the morning ,I reckon it'll go straight through
Need to give it a clean and sort out the fade to grey trim first then some wheels .
Gotta say mate I reckon that's damn fine.. and I want that Elf sticker that's in the tailgate screen.
If it would come of you could have it but I'm afraid it's rather brittle
Really pleased with it ,starts on the button and everything works ,even the original ? tape deck .
Was only kidding mate.. I knew it wouldn't come off !
Nice motor tho' nonetheless, I know it ain't a GTT but the basic 5 still looks pleasing and I do a double-take whenever I see one. The old dear down our road has got an N reg 1.4 Campus.. I got it started for her a while back (flat battery), the engine bay has got enough room in it for a small gathering of buffalo!
rims ???
What's the score with lowering and what will fit ? Thinking banded steelies wiv a stretch .Torsion bar ? Pig to do ?
Answers on a postcard please
Torsion bars are easy on these, either create a puller to pull them out, theres no torx etc holding them in, just a plastic end cover. Of if you dont have a puller you can smash them all the way through and out the other side.
Cheers dj .That sounds easy enough
Barstewards ...excessive corrosion within 30cm
Front bearing play ( new,just not tightened up ) sorted .
and a number plate bulb ..
Got to go and have a lie down now as I've gone and done some detailing Worryingly it's quite satisfying .....DOT4 ftw .
I need to go and bodge something up now on the GTA and rattle can some satin over the dead insects on the bonnet to mend the status quo .
Ah, going for the mini monster truck look then
Of course we need to do some lowering but GTA turbines fit 6"x 15 and even the 8.5" rears...
Need a 6 mm spacer ish on the rear but I have first refusal on a set of rears with big stretch
Just need to convince Me-Dawny that they are safe and , as they will cost more than the car did ,that it makes sense
She is asking silly questions like " why can't we just keep the wheels that are already on it "
looks good! alot cleaner than mine!
how the hell did you get the bumpers to come up like that?????????