valve clearances

**joegtir** · 23-09-2008, 11:12

New poster! (less than 10 posts)

hi all, can someone please tell me what they shud be ???
thanks

**James5** · 23-09-2008, 11:26

What cam you using?

**paul-11turbo** · 23-09-2008, 11:28

New poster! (less than 10 posts)

inlet 0.20mm (0.008in) exhaust 0.25mm (0.010in)

**phase i 16 v turbo** · 23-09-2008, 11:47

Originally Posted by paul-11turbo

New poster! (less than 10 posts)

inlet 0.20mm (0.008in) exhaust 0.25mm (0.010in)

When the engine is cold. On a standard cam.

**Mart** · 23-09-2008, 11:49

0.15mm inlet, 0.20mm exhaust, cold, standard cam.

**joegtir** · 23-09-2008, 12:02

New poster! (less than 10 posts)

yeah its a std cam , 0.20 and 0.25 is what is says in haynes but iv been told a few times it was wrong

**James5** · 23-09-2008, 12:06

Originally Posted by Mart

0.15mm inlet, 0.20mm exhaust, cold, standard cam.

Agree with Mart always done this on my standard cammed 5 and was spot on.

**Brigsy** · 23-09-2008, 12:11

Ive always done .20mm , .25mm exhaust on a std engine (cold) as per the cup manual, never had any probs or tappity engines

**Sy5GTT** · 23-09-2008, 12:11

Originally Posted by James5

Agree with Mart always done this on my standard cammed 5 and was spot on.

I always use these too.

Re: valve clearances