clutch alignment tool

[Adey aka Ewok]

any1 remember how 2 make a clutch alignment tool out of a few sockets? Used to be on the old site

[Sy5GTT]

Use your finger.

[Andrew Cooke]

Use your finger.

since the crank doesn't have a spigot you don't need to be as accurate as with some cars. Finger tips onto the outside edge of the plate works just fine.

[Purple_rob]

I second Andy, fingers around the plate/flywheel

[TNT Tricky Nicky]

i found a 1/2" extention bar done the trick

[warpspeed]

I used a sealey one this morning, cost me £2 brand new from Maccess

[Mart]

i found a 1/2" extention bar done the trick

or a suitable sized handle screwdriver, hammer, torch, etc

You can usually line it up good enough anyway by sight and/or feel.

[Adey aka Ewok]

cool beans, got the modified clutch cover done, just waiting on the 4 puc helix friction plate to tutn up and it should be back on the road, will upload a pic of the mess that was caused by a release bearing falling apart, nearly 2 weeks its been off the road cant wait to take her for a ragging

[Adam L]

I used a screwdriver with my Datsun last year, clutch fitted sweet as a nut.

[Schakal]

i usually wrap some tape around an extension bar untill
i get the desired thickness , oh errr ....

[bones660]

New poster! (less than 10 posts)

fingers . you can't do better than fingers . feel alround the plate to make sure it is equal alround the pressure plate . then nip up the bolts . job done .