simples

[James5]

Does anyone know what mods are required to fit valver leather seats into a 5??

Pics would be good aswell

Cheers James

[The new Bill J]

Opps - I forgot all about the pm you sent. Sorry Chief

Do you still want a reply?

Oh, and you'll need to make some subframes, or 'bodge' the 5 ones on. The Valver ones are way too wide for the 5's footwell.

[James5]

Opps - I forgot all about the pm you sent. Sorry Chief

Do you still want a reply?

Oh, and you'll need to make some subframes, or 'bodge' the 5 ones on. The Valver ones are way too wide for the 5's footwell.

What you like, and yes please matey.

Looks like I will be welding my 5 ones on

[philg]

If they are the same as these that were in my car when i bought it, they went straight in or came straight out

[James5]

If they are the same as these that were in my car when i bought it, they went straight in or came straight out

Phil yeah they are the valver seats I am after the dark grey version you got any pic's of the subframes on those?? they look like 5 frames from here.

[philg]

Phil yeah they are the valver seats I am after the dark grey version you got any pic's of the subframes on those?? they look like 5 frames from here.

Sorry james, i whipped them out and sold them on.


phil

[James5]

Sorry james, i whipped them out and sold them on.


phil

No probs phil, just be a simplecase of cut and weld I hope

[dangerous dave]

i've sat in some and felt like i was on the tilt sliding off them the whole time.. worth thinking about when your doing it, perhaps they need adjusting, perhaps not tho

[scratcher]

Like Bill said, you'll need to make up some subframes or cut and paste the two sets.
I got some valver seats for mine before and there's no plug and play involved

I swapped with Big Steve for some buckets... Winner

[James5]

i've sat in some and felt like i was on the tilt sliding off them the whole time.. worth thinking about when your doing it, perhaps they need adjusting, perhaps not tho

I will make sure I have a good gtt seat sat beside to make sure I get it right and some good strong welds on there

Like Bill said, you'll need to make up some subframes or cut and paste the two sets.
I got some valver seats for mine before and there's no plug and play involved

I swapped with Big Steve for some buckets... Winner

Yeah I have a few spare GTT frames now as I keep going through seats due to the crap material being so thin on the sides so was going to cut and bodge / weld the 16v seat to a gtt frame