wideband help asap

[jonnyshaw49]

hi just bought a aem wideband kit off scoff and fitted it in downpipe on 106 gti, the dial is all plugged in and lights up but the afrs are sitting at 16's and do not move when revving car, the dial just shows 3 dash lines, looked at symptoms and its looking like the the bosch sensor is at fault, anyone any ideas???

[HULK]

have you calibrated the sensor???

[TrixNFlix]

have you actualy put the car under load, ie, driven it to see if the afr's change?

[jonnyshaw49]

how do you calibrate sensor mate???tried driving it doesnt do anything thanks

[TrixNFlix]

how do you calibrate sensor mate???tried driving it doesnt do anything thanks

As far as im aware you dont calibrate the aem

[jonnyshaw49]

anyone got scoffs numba???

[HULK]

As far as im aware you dont calibrate the aem

Ahh my bad, never used the Aem

[jonnyshaw49]

just tried other sensor no difference, could it be the dial then???or am i doing something wrong, the sensor is welded in the downpipe on manifold next to the other lambda should this be ok???

[Nayls]

what does the gauge say when driving?

[jonnyshaw49]

just has 3 line dashes, the guage is sat at 16's afr and doesnt move

[Scoff]

for the sake of readers, jonny's been in contact and any problems there might be will be resolved ofcourse As for numbers, I don't do phones, if I did I wouldn't have enough hours in the weekday to get things done

[JRP]

for the sake of readers, jonny's been in contact and any problems there might be will be resolved ofcourse As for numbers, I don't do phones, if I did I wouldn't have enough hours in the weekday to get things done

i wanna phone you all the time though...