turbo speed sensor PMT version needed

[Andrew Cooke]

http://www.owendevelopments.co.uk/up...ensor_spec.pdf

go on Scoff, you know you want to...


http://www.owendevelopments.co.uk/pr...Id=27&subId=-1

[Gymnast]

Hmm, do you reckon you could modify the TDC to pick up a feed or would the blades be too fast/thin?

[Andrew Cooke]

Hmm, do you reckon you could modify the TDC to pick up a feed or would the blades be too fast/thin?

I think that might confuse the AEI

[TNT ANDY]

To what end???

[Andrew Cooke]

To what end???

setting up antilag
setting up VNT controller
checking where on the compressor map you're working

[RussellT]

I wondered if you could do this off sound like they judge F1 revs on the TV. Or can you infer it from the air flow it produces?

[Sparkie]

only way that immediately springs to mind is put a washer under the compressor wheel nut, that had either notches or is aluminum with ferrous parts machined/pressed into it. then using a small hall effect sensor on that.

[markey b]

half way down this link is a home made speed sensor

[TNT ANDY]

setting up antilag
setting up VNT controller
checking where on the compressor map you're working

Oh that