side exits

[Maka]

Only just spotted this thread. Id be interested in a 2.5 rear exit system. As mentioned probably best to get powerflow to make one on a car, then they just copy a load up. Mandrel bent ofcourse, with a big join at the elbow, i have a bigger downpipe, ktec or similar jobby and its about 2.5inch, but then where it joins the scorpion the flange on the scorpion is pretty thin!

Anyone used ktecs 2.5 inch system?

http://www.k-tecracing.com/show_prod...?id=2666&pic=2

i swapped a gt tuning 2.5 inch for a 2.5 inch ktec sidey. its a different sound for sure. i wouldnt say it was over loud either, i havent decible tested it yet though.
Its not an unpleasant sound to be ripping around the streets with.
Just dont park next to anyones car you like and fire the car up..muwhahaha

[R5GTTRaider]

yeah im also interested.
ive jumped in on the group buy fora 3inch 1piece downpipe and was thinking about getting a 3inch side exit made up but no silencers.
opinion?
cheers.

i have a 2.5 single section, no middle box, and a 3" exit but the inside dia is tiny, tho it does sound lovly on boost

[rs250nut]

I would be interested in a three inch sidey, manderel bent

[Big Jim]

I made a full 3" rear exit that didn't knock, bit fiddly routing but certainly not impossible. Also made an experimental silencer for it that managed to make it louder!!! Binned that and just made it a sidey with a single box.

[rs250nut]

I made a full 3" rear exit that didn't knock, bit fiddly routing but certainly not impossible. Also made an experimental silencer for it that managed to make it louder!!! Binned that and just made it a sidey with a single box.

Dont suppose you still have said exhaust do you?

[gttjames]

had a meassure up the other day just to see what iv got, external dimater is

downpipe 57cm/ 2 1/4 inch
scorpion system 50cm/ 2inch

Pretty thin hey? I thought the dp was 2.5inch and scorpion 2 and 1/4

[Big Jim]

Dont suppose you still have said exhaust do you?

It's on the ex CTM efi car. The rear section got binned.