US supplier of plenums bits

**Andrew Cooke** · 14-09-2008, 17:22

I recall looking at a US site that had shaped sections for plenums, runners, trumpets and fuel rails. I can't remember what it was, any ideas?
Andy

**Andrew Cooke** · 14-09-2008, 17:39

**Rob@Backyardracing** · 14-09-2008, 19:24

New poster! (less than 10 posts)

What a good site

... heres me sat thinking of a home built plenum

who says manifolds cost the earth for efi conversions blah...

**Os8472** · 14-09-2008, 19:26

Looks like someone is planning somit big

**Rob@Backyardracing** · 14-09-2008, 19:35

New poster! (less than 10 posts)

Originally Posted by Os8472

Looks like someone is planning somit big

Maybe

cant decide of my displacement tho

**Os8472** · 14-09-2008, 19:42

Originally Posted by Rob@Backyardracing

New poster! (less than 10 posts)

Maybe

cant decide of my displacement tho

oooooooo sounds interesting

**Andrew Cooke** · 14-09-2008, 19:50

Originally Posted by Rob@Backyardracing

New poster! (less than 10 posts)

Maybe

cant decide of my displacement tho

ahh, that's easy, you fill a bath with water, get in, then measure how much water has run onto the floor.

**Rob@Backyardracing** · 14-09-2008, 20:01

New poster! (less than 10 posts)

Originally Posted by Os8472

oooooooo sounds interesting

What your car idle like with your injector position out of interest...

Re: US supplier of plenums bits