-
Non-member
boost sensor
New poster! (less than 10 posts)
i'm turning my boost up from the standard 10 to 14psi, carbs been rejeted to cope, only thing is i see that k-tec say they adjust boost sensor when turning up the boost..... i don't have one fitted to the car anymore, i got rid of it when fitting samco boost pipes, wires are just hanging there unplugged
is this a problem? cheers
-
Look-Out
Re: boost sensor
not a problem just tuck them out the way and insulate them to stop them from touching
-
Non-member
Re: boost sensor
New poster! (less than 10 posts)
cheers for the quick reply so a boost sensor is not needed at all then? what was its original purpose?
-
Look-Out
Re: boost sensor
to cut a long story short, it was originally intended to cut the ignition to 1 (or 2?) cylinders IIRC if it senced you were running more boost. Basically to stop your engine from going bang on the standard setup
Someone else will correct me if im wrong no doubt
-
Re: boost sensor
all cylinders
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules