-
Non-member
t3 actuator
with these t3 actuators on ebay does any1 know if you get a connector on the end of the rod?? the pic just looks like a rod obviously i will have2 knock up a bracket.
http://cgi.ebay.co.uk/Collins-Alloy-...1%7C240%3A1318
-
Non-member
-
Non-member
Re: t3 actuator
Originally Posted by
Tiny Tim
nice 1!!!!
-
Non-member
Re: t3 actuator
You'll need bracket for fitting it on the turbo too. Also this actuator is bit bigger than classic Garrett units so your wastegate rod could be little off-center with this Forge thingy.
Last edited by jure; 11-03-2009 at 07:03.
-
Committee, NW Regional Rep
Re: t3 actuator
You might be able to use your standard connector, I did with mine.
You can modify the standard bracket to fit aswell.
I wrote an article on doing this ages ago, I think it's on the site somwhere...
-
Non-member
Re: t3 actuator
i may just pay an extra £30ish and buy the k-tec 1, sounds like alot less hassel..... think that comes with a bracket and a connector!?
i shall look in2 it thanks guys
-
Non-member
Re: t3 actuator
Yeah, it does. That is reason why I bought mine from K-tec.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules