Couple rebuild questions

[Cr23g]

Hi folks.
Got the engine in yesterday. Got a couple questions, cant remember how everything goes together.
1. Where does the speedo cable go through the bulkhead?
2. Where do the relays connected to the engine loom fix onto the body
3. Can anyone i.d any of these brackets? I now know the top one is rear lifting eye.
http://s1316.photobucket.com/user/cr...93e18.jpg.html
4. Where does the boost gauge pipe go through the dash?
5. Iv only got 8mm pipe for the fuel lines, i know its usually 6mm and 8mm but 8mm all round will be fine?

Thanks

[Cr23g]

Anyone?

[turbo ted]

For starters the two brackets on the left in the picture are not for a gt turbo,there's no speedo cable it's a wire that goes from gearbox to passenger side suspension turret along chassis rail back to bulkhead.the engine loom only has one relay that's for radiator fan,the rest of the relays lights horn etc are on a separate loom.need pictures of your engine bay to see what's going on regards rob.

[LiamR]

Get some pics up mate and people may find it easier to answer for you

[Cr23g]

No bother will get some photos up tommorow. Oh and one of the brackets on the left is the anti perc fan bracket so defo from a gt turbo, had a look on gt turbo spares website 😜

[Borms]

New poster! (less than 10 posts)



This was the routing on mine, the grey cable just below the green brakeline, goes in at that black grommet where I think the boost gauge line also attaches.

[Cr23g]

thanks borms

[turbo ted]

I meant the right side brackets in picture sorry