so who is ready for ND?

[Robbo]

And who is not, and if not what have got left to do?

[Bigfoot]

My voice is ready

Car needs:
Raising back end up - Complete just need to put shocks back on
Gear selector alignment - complete
Centre consol back in place
Brakes Bleeding - complete
Plastic covers in Engine bay
Tow eye cap - complete
Rear Lights
Rear arches
Side skirts
Clean
Insurance - paid for
MOT - booked for 10:30am
Tax

Not much really

Or remove Renault 5 passenger door from back of BMW, put in stuff, put in fuel and drive there

[Duncan Grier]

PMSL - dont have time to list it let alone do it

I have a good weeks work to fit into tonight, thu from 12 and fri until 5pm, also got a few hrs trailering to get the last of the fabrication work done.

July ND would have been sooo much easier

Weather looknig good for it so far though

DG

[BluntyR5GTT]

totally ready for my 1st nd

got a very fine fettle of the carb to do tomorrow night (1.3mm 2nd stage and 0.9 a/c) but thats it, interior is all clean and exterior was clayed,polished etc last sat so will be a quick wash fri evening ready for the off sat morn

[Penfold aka The Dealer]

If i feel upto it all I have to do is put some diesel in the Learner car....

[James5]

I wish I was ready I am so close yet so far why oh why did I start an engine conversion this close to nat day converison in 12 days must be some kind of RTOC record and almost done. Think I have some wiring still to do for the ECU and hence my injectors not working.

[SP33DY]

Theres no way I'll be ready, an OP in Feb put me out of action or 3 months and the place doing my manifold and exhaust have had the car since the beginning of May and still haven't started work on it

[soapymech]

just some polishing left going to try these (2 for £5 bargain)

[Matt@CodeRedMotorsports]

If i feel upto it all I have to do is put some diesel in the Learner car....

And a load of track wheels in the boot for adey.....? Hehehehe!

[Alex]

Nearly. I need to fit some radiator cowling and give the car a quick check over and clean etc and it'll be sorted. 

[jesus in the seat of a 5]

got all my gubbins up together , just gotta get to kris m`s place at 7am on friday , start the cup, do a few checks.... then off we go...

[Lomo]

Managed to get 99% of the jobs done this afternoon.

Still not happy with how she's running a little warmer than usual but I do know she's in need of a new rad pretty soon. Still, sits right in the middle of the temp dial now!

Gonna do the last little bits Friday morning then meet the NW crew @ 4pm

[bod 182]

IM chilling this National day just got a new ride had the discs and pads done,full service and belts done so may venture out onto track for a few laps

[Matt Cole]

Im way off! Fitting gearbox, new manifold, new turbo, welding, pistons, rods, new cams..................the list is endless!!


Robbo, im up for a passenger ride though!

[Gibbo69]

All done and ready to go

[Robbo]

Im way off! Fitting gearbox, new manifold, new turbo, welding, pistons, rods, new cams..................the list is endless!!


Robbo, im up for a passenger ride though!

thats if mine makes it down there

[Big Steve - Raider]

Booked the day off work on Friday to just make sure that i've got everything ready to rock!

Was going to change the oil tonight but just before I dumped the old stuff I checked I had a new oil filter & you guess it

Tracking down a new filter tomorrow then!

[James5]

I wish I was ready I am so close yet so far why oh why did I start an engine conversion this close to nat day converison in 12 days must be some kind of RTOC record and almost done. Think I have some wiring still to do for the ECU and hence my injectors not working.

I am cutting it fine got injectors to fire on the conversion but 2 injectors are fecked hopefully have some more by friday

[Bigfoot]

I am cutting it fine got injectors to fire on the conversion but 2 injectors are fecked hopefully have some more by friday

What was the problem in the end?

[James5]

What was the problem in the end?

I missed 3 ECU live wires, well I assume that was the problem, as I took the rail off after doing the wires and 2 of the injectors fired and 2 didn't, I still have spark and everything so I assume the 3 wires, I have basically now used all the wires on the clio loom brown and white plugs and now bodged into my 5. Done the test on the inectors like you said and couldn't free the 2 knackered ones up so have 4 more 802's on the way

[Bigfoot]

I missed 3 ECU live wires, well I assume that was the problem, as I took the rail off after doing the wires and 2 of the injectors fired and 2 didn't, I still have spark and everything so I assume the 3 wires, I have basically now used all the wires on the clio loom brown and white plugs and now bodged into my 5. Done the test on the inectors like you said and couldn't free the 2 knackered ones up so have 4 more 802's on the way

Did you try swapping the two working injectors for the non working ones, could be wiring rather than the injectors. It was worth a shot freeing them up like that, but more than likely because sitting around that long they have gone

[James5]

Did you try swapping the two working injectors for the non working ones, could be wiring rather than the injectors. It was worth a shot freeing them up like that, but more than likely because sitting around that long they have gone

Yeah tried swapping them around the 2 working injetors and they injected, have put to working OE injectors in for now as I just want it idle so will try tomorrow and hopefully friday another set of 802's will turn up for me to install

[Bigfoot]

Yeah tried swapping them around the 2 working injetors and they injected, have put to working OE injectors in for now as I just want it idle so will try tomorrow and hopefully friday another set of 802's will turn up for me to install

Well thats good news then, I thought you need 803s for that engine or is it set to run on 802s

Just turned my entire room inside out trying to find my V5 for the car, its found now but dont think my loom looks too good now

[James5]

Well thats good news then, I thought you need 803s for that engine or is it set to run on 802s

Just turned my entire room inside out trying to find my V5 for the car, its found now but dont think my loom looks too good now

the engine had the 802's in it done some research and the fastchips high boost was done on the 802 injectors.

[Purple_rob]

Booked the day off work on Friday to just make sure that i've got everything ready to rock!

Was going to change the oil tonight but just before I dumped the old stuff I checked I had a new oil filter & you guess it

Tracking down a new filter tomorrow then!

Steve, got one here you can have and replace if you get stuck.

[f0xy]

Ran my new engine in last night, all ready to go now. Hope the forecast is correct as ive only got one set of wheels to bring this time, and slicks are fitted to them

[Coops]

refit steering wheel shroud, fit wrap round seat and clean the mo fo

done :-)

[philg]

Ive got no chance to, gearbox needs referbed and refitted, my rad and water pipes fitted, boost pipes, bonnet, grill, bumper, fit my new aem stuff and get another 200 miles on her, then whack up the boost and hope its fueling ok

Hope you all have a good day though

[REBEL GT TURBO]

im all set to go, just do some polishing fri nite! Fill her up on sat morning and srt off!

[Hoolio]

I was going to say just an oil change but just retrieved the tent and its got really damp. No tent no saturday "and" sunday at the moment.

[dave r5]

I'm well behind. It's Thursday's afternoon. I'm at work till 6.
Gota service a jeep tanite, and my engine for my 5 is still on the engine stand. Heads on and all timed up. Tho. Fridays Gona be a long night.

[R5TURBORON]

Just cleaned mine need to sort camping gear that's about it

[Bass J]

My cars ready i even installed a sub and amp in the back just for the journey down

first year i aint rushing about like a madman ...all i gotta do is go shopping and pack me clothes

[Adey aka Ewok]

reconect the handbrake cables, check over all the fluids, find the tent, pop to tescos fill up and all being well with fingers crossed she will get there fine. if anyone traveling there tomorrow pass a broken down silver 172 its me so pull over

[BluntyR5GTT]

I am now officially sorted carb is spot on even got it on the safe side. Also done the oil change all iv gotta do is give it a quick wash n polish again tomorrow after work.

[D4WNO]

I've just been and bought a pile of booze, then I'm going to pack some clothes and get in the car...done

[BluntyR5GTT]

gutted i cant be there on the fri nite so i could get on it with you lot, but the mrs is coming hence why we aint setting out till sat morn

[Tony Walker]

just took my fuel tank out, repaired the stupid bung thing, refit it tommorrow along with exhaust and brake cables, fuel filter and pump. adjust my tracking a little bit, check ride height is even all round, get tools/spares together, (ideally would like to adjust my calliper extenders as my callipers are far too close to the wheels) Then meet up at 4pm

[Big Steve - Raider]

Steve, got one here you can have and replace if you get stuck.

Thanks for the offer Rob!

I managed to get hold of one today though in at a Renault Stealership in Bury St Edmunds of all places!

Oil changed tonight & a quick clean & we're all ready to rock in the Big Steve Camp!

[youngscottie]

cars packed and ready
just to buy beer in the morning
if you see to drunk scots wandering about be sure to say hello

[royz]

all done. just got to get the beer and ice tomorrow after work and head down

[Purple_rob]

Thanks for the offer Rob!

I managed to get hold of one today though in at a Renault Stealership in Bury St Edmunds of all places!

Oil changed tonight & a quick clean & we're all ready to rock in the Big Steve Camp!

Brilliant!!, Wallace sent me a text the other day about his plans on going. I was tempted to come but I cant see tickets are available anymore!

[Bigfoot]

MOT booked for 10.30am, all put together just need to put rear spoiler on and gear gaitor and give a quick clean in the morning before I take it to the MOT station, its moving backwards and forwards which is great. Front end still too high but doesn't look so bad now the back end is up by a couple of inches.

[The new Bill J]

Brilliant!!, Wallace sent me a text the other day about his plans on going. I was tempted to come but I cant see tickets are available anymore!

Get your ticket on the gate Rob. Go on, turn up! I don't think I've seen you since about 1963

Have you still got your grey 5?

[BWilkie]

Which way should we go?

M25 M1 or M11 and cut accross?

Worried about traffic on M1.....

Thoughts?

[Big Steve - Raider]

Which way should we go?

M25 M1 or M11 and cut accross?

Worried about traffic on M1.....

Thoughts?

Depends what time you're going matey??

The Motorways could be cool but on the other hand it could be a nightmare on a Friday evening??


If I were you I'd be tempted to try:

• M25
• M11
• M11 Jct 13 west A428 Past St Neots to the A1 (Helps you miss out on all the crap on the A14) And you get to drive past my house (if you know where to look! )
• A1 North to A14 Westbound towards M1
• Off the A14 at Jct 1 to miss out on the usual A14/M1/M6 Friday Evening Sh1t
• Back roads to Mallory all the way

See Google Map below:

At least it's better than sitting in traffic & either you or the car won't get too hot?

[Big Steve - Raider]

don't Forget Your Driving Licences Guys!!!!

[Purple_rob]

Get your ticket on the gate Rob. Go on, turn up! I don't think I've seen you since about 1963

Have you still got your grey 5?

South mimms wasn't it, and yes it probably was that long ago lol. I've got to rearrange work and convince the boss at home. I do have a 3 week older daughter so it might be difficult.

It's good to know I can get a ticket though so I'll try. Wallace, if you see this, I'll buzz you tomorrow mate.

[Lomo]

The Sun is shining and the weekend awaits..

Its National Day Time!!!

Have a safe journey everyone

[Adey aka Ewok]

indeed, just got up guna go get shiz ready then head off later