oil return bends

[tom t]

i want to replace my oil return silicone hoses.
ive got the phase 2 metal return pipe,

but i think the sump ive got is a phase 1 possibley as im sure the hole on the sump is smaller then my old one. as i have just changed the engine.

what are the measurements of the part on the sump does any1 know?

and if it was the smaller phase1 sump, would it be ok to use a 90degree reducer ?

and what size would the other 90degree bend need to be? cheers

and does any1 recommend anywhere to buy the bends from? cheers

[James5]

Sump end 16mm other end 22mm i think

[tom t]

cheers bud would you know about the mm of the other bend off the turbo? cheers

[TBM1397]

turbo end is 22mm-22mm..
get it here

http://www.rallydesign.co.uk/product...ducts_id=14034


and on the sump end you want this..

http://www.rallydesign.co.uk/product...ducts_id=14111

i had the same problem..

[tom t]

cheers bud yeah i was just looking on rally design

[raj]

remember that std coolant/air silicone hose is not ideal for oil. the silicone hose should be fluro lined if its to be used with hot oil

[tom t]

just looked on here http://hosesolutions.org.uk/index.ph...roducts_id=288

how can they justify the price difference in these two?

http://www.rallydesign.co.uk/product...oducts_id=3692

cheers