Results 1 to 2 of 2
  1. 27-06-2010, 23:17 #1
    adamwallace1989
    Guest

    Non Sarter

    hi every one i hope you can help me. This weekend i put the b18ft into my clio rsi, at first the car did not start but i later found out it was because i had the ecu's connected to the wrong connectors :-/ After switching these the car started, i let the car get up to temp without the vacum pipe on the icv.(because i forgot to connect it) i then connected it whilst it was still running, it reved up a bit and adjusted. after i turned the engine off it will now not start unless i bridge the fuel pump relay. has any one any ideas
    Reply With Quote Reply With Quote
  2. 29-06-2010, 10:49 #2
    adamwallace1989
    Guest

    Re: Non Sarter

    Found out the problem to this after a good couple of hours of studying the wiring. i had the tdc sensor wired up backwards
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules