what can the pistons liners etc handle?

[w35ty]

well my build is coming back together and il be ready to put my engine back in soon,

i have the following:
piper 285 cam springs pulley
group a carb
L & B flywheel
oversize downpipe and sideexit
font mount intercooler
and standard t2 at the min

next things i was going to get were maybe a t25? and a stainless manifold.

will the standard picstons be ok for this or will i need to forge? also what kinda bhp figures?

[IANMM]

get turbo forget the manifold as standard is fine and unless you want to run 30psi + standard liners are fine

ian

oh and if ya get stuck come down the unit

[IANMM]

and if you want a T25 speak to this guy

https://www.rtoc.org/boards/member.php?u=186

[w35ty]

nice one for that mate il get a t25 then..

[D4WNO]

and if you want a T25 speak to this guy

https://www.rtoc.org/boards/member.php?u=186

Best off phoning him at work, he isn't online much these days

[rs250nut]

Some people say any prolonged use over 1.5 bar and the ringlands will fail but some people have used them at a lot more, including me

[w35ty]

what turbo you using mate? and what boost pressure?

[markey b]

Some people say any prolonged use over 1.5 bar and the ringlands will fail but some people have used them at a lot more, including me

+1

3 of my pistons are original from the build many miles ago, and 3 of the liners are too, std machined pistons, std liners, std exhaust manifold and 1.9bar

[w35ty]

good to hear!