has anyone got a finished map i could use just as a tempory measure ive got i base map but it literally cuts out once the car is hot and wont start again until its cold any ideas ????? i was gonna see if i could load a finished map on there an see how i get on the spec as follows :
micheal t manifold
bosch red injestors
t28 turbo
285 cam and pulley
any advise apprecitated
i'll send 1 in a while......send email address
nice one buddy
Could be coolant compensation
I have maps but not for a C1J, I don't mind taking a look at your map if you email me a copy over
got a map to the same spec you can have a try of
yeh if you wouldnt mind is this just the base map or mapped on the rollersOriginally Posted by royz
sorry for the late reply.
might have a slight problem just remembered I have mine set up to run sequential injection. where I use the standard Renault wheel for triggering and a senor attached to what was the old dizzy to give the ecu a reset point. so might not work. I have the base map that was sent to me so I could at least run the car and get it to EFI parts when I then had it fully mapped.
Last edited by royz; 17-07-2015 at 20:43.
Hi got it running ok with the map mike emailed me but still running very rich I'll send it over what's your email cheers 👍👌I have maps but not for a C1J, I don't mind taking a look at your map if you email me a copy over
May I also ask those maps?
I'm having some jerkiness as I get on and off the trottle and I think that my decel area is not good mapped.
Posting Permissions
Reply With Quote