-
Non-member
camber correction
I have fitted some camber correction bolts as my tyres have worn out on the inside edge but i keep getting a tyre squeak when cornering. I have turned it lock to lock and the tyres are nowhere near anything. the car is dropped 30mm and on 195/45r15's so nothing too drastic, can it be where the tyre is worn wrong and its not used to sitting like that
-
Non-member
Re: camber correction
Tracking/toe angle all ok?
-
Non-member
Re: camber correction
was toeing out i have adjusted it so its toeing out but only slightly. mat i was hoping to bring it to you at some point to have it set up properly as it has never felt right at high speed if thats ok.
-
Non-member
Re: camber correction
Fine by me mate, come and visit 'code red towers' when ever you like!
Just out of interest, what lower arms, struts etc ... are you using?
-
Non-member
Re: camber correction
standard swingarms, std hubs, koni sport shocks, pollybushed, ph2 strut tops and polly doughnut. I will be collecting some valver hubs, arms, arb etc... soon so could bring them and sort that all out as well i guess.
-
Non-member
-
Non-member
Re: camber correction
ace il drop ya a pm when i have picked up the other bits and arrange a time to pop over
-
Non-member
Re: camber correction
It will most likely be tracking is a mile out if the inside edge is wearing off.
-
Non-member
Re: camber correction
it was out quite a bit gave the track rod 3 turns out and that has made it a bit better.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules