-
Non-member
Clunk noise + brake advice.
When I put foot down I get clunk from what I think is drive shaft.
I changed to a new drive shaft while doing this noticed suspension top mount was cracked.
After taking it apart found whole lot has gone. Replaced that.
Still get a clunk from what I think is the drive shaft. :S
Its definitely not a mount, had it over pit and checked everything.
When I put foot on throttle its just a clunk. :S
Other question is my brakes are terrible. They have been on the to do list for a while. Front pads have lots left. rear need changing. but when i say bad I have to pre emptive brake from ages away. This is with EBC green stuff pads and vented discs.
What would cause them to be about 20% efficiency at last mot just passed (before i brought car).
I am thinking bleed them refill with fluid and change rear pads should sort it?
-
Non-member
Re: Clunk noise + brake advice.
One way valve in the inlet to servo still working? Poss duff servo or MS.
-
Non-member
Re: Clunk noise + brake advice.
I had this once in a mini - turned out to be a can of Fosters under my seat
-
Non-member
Re: Clunk noise + brake advice.
Cheers I'll check it. What order is it to bleed brakes?
Pedel doesn't push in very far so reckon u might be right.
Still gna bleed n refill tomoz
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules