As above i have the kit with the gauge. the gauge has 4 wires white, red, yellow and black. Anyone know what the wires are?? The analogue out 1 and 2 (yellow and brown) need to wire to the gauge, but which one??
**** instructions!!
As above i have the kit with the gauge. the gauge has 4 wires white, red, yellow and black. Anyone know what the wires are?? The analogue out 1 and 2 (yellow and brown) need to wire to the gauge, but which one??
**** instructions!!
you only use one of the analogue o/p from the controller, to the analogue input in the DB gauge thing. You need to connect 12v and gnd to the DB gauge too.
cheers scoff, i think its analogue output no.1 i need which in the book states :1.1V=14AFR and .1V?
Analogue 2 is set as 0V = 7.35 AFR and 5 V.
So i would only need 3 of the wires from the gauge. Which 3 though?
you'll want the 0-5v output for wideband, the 0-1v will be narrow band simulation.
Cheers, i'll wire up and hope for the best!!Originally Posted by Scoff
No manual I presume? I found installation to be quite easy using the manual step by step...
i found the quality of the instructions better than the LC1 itself.... lol
anyone want one for spares, mine lasted about 20mins before it broke
I think some may have had issues but a lot have been sold and seem to be ok. I would have sent it back matey??i found the quality of the instructions better than the LC1 itself.... lol
anyone want one for spares, mine lasted about 20mins before it broke
car was off the road for a long time, and i couldn't remove it, so its about 2 years out of warranty now.. chopped out the wires the other day when i was in that area, but had to leave sensor in as i lost the bung
Red - Switched 12v,
Black - Ground wire - connect to the same ground as the LC-1 white wire,
White wire to LC-1 Brown,
Yellow wire to a light activation source i.e. rear of OE clock or to headlight switch
Or see manuals attached
Posting Permissions
Reply With Quote