Results 1 to 4 of 4
  1. 31-05-2009, 12:33 #1
    richi
    richi is offline
    Non-member richi's Avatar
    Join Date
    Sep 2008
    Location
    manchester-kinda
    Posts
    156
    Post Thanks / Like

    engine out

    right i have dropped my engine and all the subframe out, sending of the frame for sandblasting so whilst its all out is there anything i should change? putting in a new set of poly bushs and new track rod ends cause one is naff anything else you would recommend thaks
    Reply With Quote Reply With Quote
  2. 31-05-2009, 12:37 #2
    Chris Hebden
    Chris Hebden is offline
    Regional Rep Chris Hebden's Avatar
    Join Date
    Sep 2008
    Posts
    1,237
    Post Thanks / Like

    Re: engine out

    I am changing clutch cable and throttle cable now its all out, any brake pipes that look a bit suspect i would change at this point as well, engine mounts....................... all i can think of
    Reply With Quote Reply With Quote
  3. 31-05-2009, 12:58 #3
    J$£5GTT
    J$£5GTT is offline
    Non-member J$£5GTT's Avatar
    Join Date
    Oct 2008
    Location
    THE BAT CAVE
    Posts
    3,560
    Post Thanks / Like

    Re: engine out

    in general just give the bay a very good clean.
    Reply With Quote Reply With Quote
  4. 31-05-2009, 13:20 #4
    richi
    richi is offline
    Non-member richi's Avatar
    Join Date
    Sep 2008
    Location
    manchester-kinda
    Posts
    156
    Post Thanks / Like

    Re: engine out

    going to rewire the bay as there is loads of cables knocking around that are redundant and the massive connector block is just an eye sore lol
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules