Had my 5 setup today ready for the pod

[gttjames]

Went to see 1320autos where tommyb works (nice one for hooking me up tommy!), got my 5 on the rollers and plumbed in abit more boost. Was quiete interesting as found out the car must have a different cam in it as the power curve didnt tail off right up untill 6500/6700. At 17psi it made just under 190bhp, on what i thought was a standard engine as far as i was aware.

all i know iv done to it is a pipercross filter, enlarged downpipe (2 1/4inch), scorpion 2inch system, put a valeo green box volvo clutch in it, custom fmic and pipework, phase 2 fuel pump and a few other bits like alloy carb lobster, thick plug leads, and a recent service, and a t2/25 turbo with a .47

I was expecting to run 18/19psi, and get around 160-180, so am really pleased its making that power at a lower boost level.

Made 187.5bhp / 6565 rpm (104mph), and 163.1 lbft / 5291 rpm

[Blick]

good stuff!!!!! i`d be happy with that power...... really do need2 get mine on the rollers.

would it not go on the rollers with the front bumper on?? i may have that trouble as mines pretty low.

[gttjames]

yer im well happy, am running less boost than i expected! did think about puting boost up abit more to see what it could have made.

yer had to take bumper off, dont take long though

[Markey Mark (BD)]

Thats a nice bit of power you got there mate for the boost, should go quite well on friday for you

[Gttnutter]

Thats a nice bit of power you got there mate for the boost, should go quite well on friday for you

mark, looks like plan B then if we can get it set up thursday still? only a couple of runs though due to that clutch problem i'm weary of

[RICHIE]

tommy's workshop is absolutely quality. was the carb setup there or was it just a power run mate

[Ricardo]

Nice BHP figure although i would have thought the torque figure might have been closer to the BHP. Would it have something to do with taking the revs higher and torque fading off?? Not knocking it, it's a genuine question as on both my power runs the 1st made 180bhp and torque, the 2nd C1J made 174bhp and 176 ft/lb.

Could it be the way the carb has been fettled?

[gttjames]

tommy's workshop is absolutely quality. was the carb setup there or was it just a power run mate

yep carb was done there

[gttjames]

Nice BHP figure although i would have thought the torque figure might have been closer to the BHP. Would it have something to do with taking the revs higher and torque fading off?? Not knocking it, it's a genuine question as on both my power runs the 1st made 180bhp and torque, the 2nd C1J made 174bhp and 176 ft/lb.

Could it be the way the carb has been fettled?

urm... pass?

[gttjames]

Thats a nice bit of power you got there mate for the boost, should go quite well on friday for you

lets hope so