Originally Posted by Misky
Just thought would the tdc wires affect the strating problem?
As its in a right state! 2 connection blocks found on it and one came undone and I wasnt sure which way round they went as the fools used differnt couloured wire.
I want to replace with one length of wire anyway what type should I use?
Sounds like TDC sensor is your best bet first mate... new they are only a few quid, so for peace of mind id go new. However, any reasonable thickness two core wire will suffice as an interimm, originaly they are red and white, about 0.5mm^2. If you get them the 'wrong' way round dont worry, that'll just give you some ignition advance at the lower end - see articles section on the site. Id solder and heat shrink them carefully though, the signal is fairly weak.
Reply With Quote
