-
Non-member
Got a droopy rear bumper
Is it normal for the rear bumpers to droop?
I can lift mine a good inch to make it levels and are there only supposed to be 2 bolts holding it in place?
If not what's the cure, mine have had about 2 inches cut off the arch ends and the bottom middle section has been cut out and was wondering if this is what's causing it. It also has no rear exhaust to lean on either as I have a side exit.
It's annoying because you can see it is not straight like some photos I have looked at.
Any help appreciated.
-
Non-member
Re: Got a droopy rear bumper
are you using the 2 bumper blocks??? if they aren't right, the bumper wont sit right.
-
Non-member
Re: Got a droopy rear bumper
The rear bumper is held on by two bolts at the sides and two brackets on the bottom that bolt to the chassis, if these are missing/broke the bumper flops down.
The blocks shouldn't really make a difference to how it sits unless said brackets are missing.
-
Re: Got a droopy rear bumper
Rusty mounts? If your bolts are tight then its worth taking the bumper off and checking the mounts.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules