Results 1 to 2 of 2
  1. 23-11-2008, 19:21 #1
    rs250nut
    rs250nut is offline
    Non-member rs250nut's Avatar
    Join Date
    Oct 2008
    Location
    Learning you can't teach stupid.
    Posts
    2,091
    Post Thanks / Like

    Heater controls and aeroquip.

    The switch for the heater has four wires on it and because I dont have the panel that switch gos in I have made my own with carbon fibre, which of the two wires can I connect to a two pole switch to have the heater on full? If I had a multimeter it would be easy but I dont. Sorry to be cheeky but I want to make up an oil feed hose with aeroquip does anyone know what bits I need or the thread sizes for both the turbo end (2554r) and where it connects to the engine. -6? Cheers in advance chaps
    Last edited by rs250nut; 23-11-2008 at 20:01.
    Reply With Quote Reply With Quote
  2. 24-11-2008, 13:42 #2
    markey b
    markey b is offline
    Non-member markey b's Avatar
    Join Date
    Jan 2003
    Location
    Bury St Edmunds
    Posts
    3,126
    Post Thanks / Like

    Re: Heater controls

    there is one positive 'in' and 3 'outs' for the speed.. get a multimeter to determine which one is +12v at ignition on, then touch that wire onto the other 3, one at a time, to determine which one is the fastest speed. i did this on my old car as i had hi and low fan speeds on toggle switches
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules