Just put my engine in and I have a couple of things not sure about. First pic where do these wires go to and second pic are these oil cooler pipes suppose to move when they are tightened and is there a bracket or clamp to go on them.
Just put my engine in and I have a couple of things not sure about. First pic where do these wires go to and second pic are these oil cooler pipes suppose to move when they are tightened and is there a bracket or clamp to go on them.
Anti Perc fan wires by the looks of thing, also don't worry about the oil lines, there ment to move like that, just make sure they don't leak.
What part of the anti perc fan system do they go on? the only thing I have left with no wires on is the switch just below the carb it screw into the manifold, unless I have something else on wrong.
I think those ones are for the sensor that goes on the top of the o.e. heat shield, should also be a pair going to the one on the carb to, but doesn't matter as long as one of them connected if your using a Perc fan.
Ok, I think they are for the heat shield the wire is very stiff compared to the others. The wires that go to the carb are missing which is strange as its a new wiring loom.
Cheers.
The carb connections literally link back from the orange and blue ones anyway. I believe they are connected to the same,
Charlie there is an L-shaped bracket exactly like the one that secures the same pipes to the front of the block.
I wouldn't worry about it, as long as it on one of them your good to go.
Must see if I can get one somewhere.Originally Posted by mingblus3
Cheers guys.
Posting Permissions
Reply With Quote