whats the opinion on the powerflow side exit system is it worth a change? i have a general stainless out the back jobby?
whats the opinion on the powerflow side exit system is it worth a change? i have a general stainless out the back jobby?
I've had bad experience's with Powerflow in the past so not really into there stuff. They don't make a system as such, all there exhausts are custom made on the spot so no 2 are the same.Originally Posted by Ross99
Got a custom 2.5" powerflow side exit on my GTT just bloody loud but I do like thankfully it's not the main car
Last edited by James5; 14-10-2008 at 21:15.
when I investigated getting an exhaust for my bus they told me they just graft onto my original downpipe as "they never rust". I'd put them down as shiney ****e.
Sounds like what they done to mine mate with the downpipe, mine had about 30 bends in it and a silencer which was 1.75" bore when i had a 2.5" system madePiece of crap really.
i dont rate powerflow at all, but bods old car, now james's was a good job.
the sooner i remove my sidey and fit a 2 1/2 rear exit the better as sideys piss me off now.
they sell em at halfords m8......say no morenot as good as there tools...there ok.
The fella that did my side exit at powerflow in ST.Albans had two renault 5 gt turbos so knew his stuff and did a fantastic job cannot fault that system
depends completley on the fitter...
New poster! (less than 10 posts)
i have a bbpt job on the clio, top piece of kit, altho my only compaint is the box in it is a bit big, and with the car being quite low it catches on speed bumps etc so i have split the welds on it a few times, easy fix tho, get the lads at work tac it back up again
Posting Permissions
Reply With Quote