-
Non-member
piston liners
how much of a shoulder is to much to salvage a liner,
or can they be honed out an use a larger diameter ring?
-
Non-member
Re: piston liners
You could messure them either with a 3 way bore mic or drop a ring in and messure gaps... You can de glaze them with a self honing tool to help clean them up... If you start re boring the liners will just get to thin and i dont think oversize pistons are available... could be wrong.. but at least you could make the perfect P2W clearance to match your build.
-
Non-member
Re: piston liners
the particular pistons an liners i have are just spares an was just going
to see if they are re-workable,the self honing tool i have seen,it has a
setting so you dont over work the liner right?
-
Non-member
Re: piston liners
Pre-load on a spring i think, i havnt used mine in a long time... just keep them as spares...
-
Non-member
-
Non-member
Re: piston liners
I have never come across liners to worn not to be reused.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules