I have a new loom and I have connected everything up but I still have these two connectors spare. I did think they were for the anti perc fan turbo heat shield sensor, but the connector is metal and wires them together and therefore the perc fan would run if this was plugged in to this holder??
I joined the connectors which I had put to the carb base switch together and the perc fan fired up so I know that works.
Also on a separate note I started the rebuilt engine in my car yesterday and that's the first time I've heard it running since 2009! Hopefully not long till it's back on the road but I need a full respray first!! Started like it had never been off the road!! Have had a big grin on my face all day!!
Just wanted to say thanks to the club as I have obtained a lot of knowledge and help from reading over the years, but I'm not really one for posting much!
Steve