-
need help - is this part different to normal
Right - I recently replaced the oil pressure sensor on my raider but then realised it wasnt the sensor that was leaking but the metal pip it connects to had a split in it and oil was pouring out
I had a spare ready to go on but its different - the one I took off had another sensor coming off the side of it so I would like to get another one the same
Just wondering if this is a normal part or perhaps off a clio or something?
-
Committee, Shop Manager, SE Regional Rep
Re: need help - is this part different to normal
Somebody has drilled a hole in the side, threaded it and put that sensor in place. It is not standard like that.
-
Re: need help - is this part different to normal
any idea what that sensor is for - there is now a wire that isnt connected
Oil pressure sensor is dodgy too so ill have to get a new one anyway
-
Re: need help - is this part different to normal
I would say that is a oil pressure switch should have a light in the dash when key is turned then go out when the oil pressure gets up when engine started
-
Re: need help - is this part different to normal
no the oil pressure sensor goes at the bottom of that - im getting pressure (a bit iffy though) and the red light isnt coming on
-
Non-member
Re: need help - is this part different to normal
That is a later ph2 banjo with the oil light sensor in the side. Either one will fit fine, i prefer the early one with the barrel on bottom and two prongs as the later type tend to leak.
-
Re: need help - is this part different to normal
so should the wire that is now disconnected go to the 2nd prong on the oil pressure sensor (I now have the phase 1 type sensor fitted)
-
Re: need help - is this part different to normal
mine was leaking from the narrow tube in the middle - had a crack pretty much all the way round it
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules