-
Moderator
South East Regional Rep
First issue with rebuild.....
I am have come across my first issue, it's only a small one and I am sure there will be more but a spot of help would be appreciated please....
There is a bracket that comes off the bottom of the down pipe with a support bar connected. Where on the block/head does this connect to?
Need to get this done so I can put on the manifolds, starter loom and starter heatshield...
-
Member
Re: First issue with rebuild.....
i think the support bar is bolted to one of the manifold studs
-
Moderator
South East Regional Rep
Re: First issue with rebuild.....
That would make sense. Can anyone else confirm???
-
Non-member
Re: First issue with rebuild.....
I bent my bar to bolt to the threaded stud on the back of the block. Easier to fit and less stress on the head.
-
Non-member
Re: First issue with rebuild.....
The bar bolts on to one of the manifold studs, the plate bolts to the block.
-
Non-member
Re: First issue with rebuild.....
This is where the oe one should bolt.
But due to me running a tubular manifold and there not being much room I now run one off the block.
-
Moderator
South East Regional Rep
Re: First issue with rebuild.....
Cheers mate
That pic was perfect! Good bit of handywork making your own bar to connect to the block too.
I am practising my welding at the moment, and god am i awful!!lol. Not going anywhere near the 5 yet!
-
Non-member
Re: First issue with rebuild.....
I wish I could weld I paid for that to be made for me.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules