rev limiter wiring

[r5 rich]

I have a omex clubman rev limiter and need to fit it to my engine asap!

If someone can help me locate where the wires go to I would appricate it.

picture below!

http://www.rtoc.org/boards/picture.php?albumid=732&pictureid=7962

[Gymnast]

Black wire is to earth

Red is to positive of coil

Blue is to negative of coil

I fitted mine yesterday, will take a pic and post it up here for you :)

[Gymnast]

In the meantime, maybe this will help.

I earthed the limiter to one of the bolts on the AEI bracket.

The coil -ive is exposed on the AEI (see pic below) but you may have to drill a hole in the AEI to expose the +ive side. Unscrew the coil from the AEI casing, it's about a 5.5mm or 6mm hole - be careful not to damage the bracket behind it.

3289

Once you have the other hole, use a female bullet connector to attach the wires to the coil. You will either have to slightly enlarge both holes on the AEI casing or strip off a little of the plastic from the bullet connector for it to fit properly.

[kial]

im stuck with this too..

could i not connect my + wire to the supressor because its a positive feed to the coil? and the - to an earth i have coming off the coil to the body?

thanks

kial