Measuring Head lol [Archive]

Kenobi

06-07-2009, 07:26

Ok so if im right i have turned this on its side and measured with tape measure that the head in front of me 1s 73mm.

Does that sound right? have i measured the right bit?

Alex

06-07-2009, 07:37

Sounds right to me. A set of verniers would probably be more accurate, but the tape measure will be fine. :)

Kenobi

06-07-2009, 12:13

So 73 is ok? or is that for the bin?

J$£5GTT

06-07-2009, 12:26

So 73 is ok? or is that for the bin?

if i was you i would make sure what width/depth it is,a tape measure
isnt the most accurate method,you want to make sure or you could
have problems with compression...
:)

Alex

06-07-2009, 18:41

if i was you i would make sure what width/depth it is,a tape measure
isnt the most accurate method,you want to make sure or you could
have problems with compression...
:)

Is that not what he's just done? :scratch:

73mm is :agree:

clee

06-07-2009, 18:43

Hmmm ..I'd use a steel rule at the very least .A tape measure is OK for woodwork but .......

J$£5GTT

06-07-2009, 19:55

Is that not what he's just done? :scratch:

73mm is :agree:

yeah but does he know,inaccurate measuring...your going to need
a steel rule as clee says minimum....