front hub and bearing

[RAGOONEY]

To change the front hub and wheel bearing is it just a case of taking the disc off then taking the big driveshaft nut off then bash it off as one complete part??:)

[Schakal]

you have to take the hub out first than seperate 2 parts by "bashing" method
once inner part is out you will be left with bearing inside the outer .
which is another bashing job from the right places after taking the locking clip out!!

the usual problem with this is the inner race of the bearing getting stuck on the inner
hub face i found ,but thats no problem if you have steady hands,a dremel and some
cutting discs :p

[RAGOONEY]

so to take the hub off..you just take the disc off, then driveshaft nut...then it pulls off?:)

[Schakal]

so to take the hub off..you just take the disc off, then driveshaft nut...then it pulls off?:)


yes ,also got to disconnect ball joint , shock absorber bottom bolts
and track rod end ;)

:coffee: