US supplier of plenums bits [Archive]

View Full Version : US supplier of plenums bits

Andrew Cooke

14-09-2008, 17:22

I recall looking at a US site that had shaped sections for plenums, runners, trumpets and fuel rails. I can't remember what it was, any ideas?
Andy

Andrew Cooke

14-09-2008, 17:39

found it http://www.rossmachineracing.com/intakepartspage.html you can stop looking now...

Rob@Backyardracing

14-09-2008, 19:24

New poster! (less than 10 posts)

What a good site :agree:... heres me sat thinking of a home built plenum :crap: who says manifolds cost the earth for efi conversions blah...:rolleyes:

Os8472

14-09-2008, 19:26

Looks like someone is planning somit big

Rob@Backyardracing

14-09-2008, 19:35

New poster! (less than 10 posts)

Looks like someone is planning somit big

Maybe:coffee: cant decide of my displacement tho

Os8472

14-09-2008, 19:42

New poster! (less than 10 posts)

Maybe:coffee: cant decide of my displacement tho

oooooooo sounds interesting

Andrew Cooke

14-09-2008, 19:50

New poster! (less than 10 posts)

Maybe:coffee: cant decide of my displacement tho

ahh, that's easy, you fill a bath with water, get in, then measure how much water has run onto the floor.

Rob@Backyardracing

14-09-2008, 20:01

New poster! (less than 10 posts)

oooooooo sounds interesting

What your car idle like with your injector position out of interest...