Cool Parts on Ebay (if a little pricey!!)

[Woznaldo]

A nice 84mm Crank, taking capacity out to 1600cc:cool:

http://cgi.ebay.com.au/ALBERO-MOTORE-CRANKSHAFT-RENAULT-5-GT-CORSA-STROKE-84mm_W0QQitemZ270240881093QQihZ017QQcategoryZ33623 QQcmdZViewItemQQ_trksidZp1742.m153.l1262

Or this lightweight Flywheel:cool:

http://cgi.ebay.com.au/ws/eBayISAPI.dll?ViewItem&item=270230570790&_trkparms=tab%3DWatching

I think these would only be for the racer limited by rules & regs as you could buy a couple of 172/182 lumps for that kind of green!

[Woznaldo]

I'm taking it that the above is a repost or people just don't get excited about cool parts that cost far too much?:(

[boostjunky]

New poster! (less than 10 posts)

Because of the strength of the pound at the moment that crank would be about £1,000,000 after a conversion lol :)

[Sparkie]

yeah, i actually had a look at the site. its very nice, but how expensive?

[Adam L]

I'd guess the block would need some extensive machining for the crank to fit and you'll be left with a fag papers width gap at one point... So i've heard.

[DK DEVELOPMENTS]

I'd guess the block would need some extensive machining for the crank to fit and you'll be left with a fag papers width gap at one point... So i've heard.


My block required machining to gain clearence for the 84mm stroke. The con rods have about 20ths/inch clearence. Have been told the low down torque is increased alot.

[Nayls]

I'm taking it that the above is a repost or people just don't get excited about cool parts that cost far too much?:(


the parts are available elsewhere,that's maybe why?